[zuhipoint]

'Support' wrote:

Thank you. What is version of your package?

Could you show Exe also?

v 8.4

[zuhipoint]

'zuhipoint' wrote:

It is a bit difficult, if the cursor is not over the area where the image should look just does not look anything. by placing the cursor over the area, the area corresponding to the image shown in yellow. The command works fine but the image of the button is not visible. Only happens if the form is defined as MDIChild, if defined as a normal button is displayed.

[zuhipoint]

It is a bit difficult, if the cursor is not over the area where the image should look just does not look anything. by placing the cursor over the area, the area corresponding to the image shown in yellow. The command works fine but the image of the button is not visible. Only happens if the form is defined as MDIChild, if defined as a normal button is displayed.

[Author]

Posts