sTitleBar not work in mdichild form

This topic has 6 replies, 2 voices, and was last updated 11 years, 6 months ago by Support.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
August 14, 2014 at 9:08 am #52252
Support
Keymaster
Hello

Could you show a screenshot, please?
August 15, 2014 at 3:29 am #52260
zuhipoint
Participant
It is a bit difficult, if the cursor is not over the area where the image should look just does not look anything. by placing the cursor over the area, the area corresponding to the image shown in yellow. The command works fine but the image of the button is not visible. Only happens if the form is defined as MDIChild, if defined as a normal button is displayed.
August 15, 2014 at 4:14 am #52261
zuhipoint
Participant
'zuhipoint' wrote:

It is a bit difficult, if the cursor is not over the area where the image should look just does not look anything. by placing the cursor over the area, the area corresponding to the image shown in yellow. The command works fine but the image of the button is not visible. Only happens if the form is defined as MDIChild, if defined as a normal button is displayed.
August 15, 2014 at 9:47 am #52263
Support
Keymaster
Thank you. What is version of your package?

Could you show Exe also?
August 16, 2014 at 1:45 am #52266
zuhipoint
Participant
'Support' wrote:

Thank you. What is version of your package?

Could you show Exe also?

v 8.4
August 17, 2014 at 2:39 pm #52303
Support
Keymaster
Can you try version 9?
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.